6
www.Aprimatic.it
4.2 INSTALLATION OF OVER AUTOMATION WITH ARTICULATED ARM
Use the articulated arm to push with doors which open outside (view from the automation).
Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the
figure; refer to the axis of the door hinges.
Fix the bracket of the articulated arm on the door, using the measurements shown in the figure.
Note: if necessary, you can change the measure H, between the automation and the door,
by replacing the spacer, using the
codes listed in the table
.
(H) OVER
automation
28
Articulated arm+ spacer H17
45 Articulated
arm
62
Articulated arm + spacer H51
Fix the articulated arm to the automation, and fix the other end of the articulated arm to the door.
Move the door in the closed position, and adjust the length of the half
‐
arm [A] so that the angle between the two half
‐
arms
[A] and [B] is the greater possible.
(*) To increase the opening force it is possible to reduce the angle and reduce the measurement of fixing of the articulated
arm, as shown in figure.
Move the door manually, and verify the correct opening and closing smoothly.
Install the opening mechanical stop (not supplied by us).
Note: the mechanical stop on the floor must be fixed in a visible position and must not create tripping hazard.
CLOSING OF THE AUTOMATION COVER
Insert the cover profile to the base profile and attach it to the heads. To prevent the cover from being opened without the
use of a tool, you can remove the pins inserted into the cover, and secure the cover to the heads at the holes, using the
screws 2,9 x9,5 not supplied by us.
