8
www.Aprimatic.it
Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the
figure; refer to the axis of the door hinges.
Fix the sliding arm on the door as shown in the figure. Insert the sliding arm in the guide and fix to the automation (
use the
screw M8 x 50
)
Note: if necessary, you can change the measure H, between the automation and the door,
by replacing the spacer, using the
codes listed in the table
.
(H)
OVER EVO automation
30
Sliding arm + spacer H17
47 Sliding
arm
64
Sliding arm + spacer H51
PRE
‐
CHARGING OF THE CLOSING SPRINGS
Tighten the screw [a] and compress the springs of about X = 10 mm, as shown in the figure.
Move the door manually, and verify the correct opening and closing force.
Adjust the opening mechanical stop inside the sliding arm.
CLOSING OF THE AUTOMATION COVER
Attach the cover profile to the base profile. To prevent the cover from being opened without the use of a tool, you can
secure the cover to the heads at the holes, using the screws 2,9 x9,5 not supplied by us.
