INSTALLATION AND HARDWARE MANUAL
ADI 1075 Pilot System
PUMPS
December 2002
8-1
CHAPTER 8
PUMPS
The Pump Section contains four positions for pumps:
Each pump position has a on/off/remote switch.
In the position “on” the pump is on continuously.
In the position “off” the pump is switched off.
In the position “remote” the pump can be activated by a
remote signal (digital output of the control device).
At the pump positions fixed speed pump drives can be
installed (in case the level control module is installed, pump
3 is used for level control).
Caution:
According to the European
Community legislation on
machinery, a pump drive is a
machine with potential
hazard. Only apply these
drives with the pump heads
and tubing that are described
in this chapter!
Do not use the tubing pump
drives for other purposes
than displacement of fluids
(or gas).
Switch off the power of the
pump drive before replacing any tubes or pump heads!
Application of damaged tubes may result in fluid leaking
into the pump drive! Verify the tube quality inside the
pump head before every fermentation run.
Summary of Contents for ADI 1075
Page 1: ......