Applikon ADI 1075, Installation/Hardware Manual, Page: 28 / 31

INSTALLATION AND HARDWARE MANUAL
ADI 1075 Pilot System
STIRRER SPEED CONTROL
December 2002
6-2
The liquid crystal display presents the current revolutions per minute.
The "Local/Remote" tumbler switch is used for the selection of the stirrer speed controller
function:
S
"Local" = stirrer speed is set manually (potentiometer at front panel),
S
"Remote" = stirrer speed is controlled by the ADI 1010 Bio Controller.
Note:
The motor fuses are located behind the rear panel of the ADI 1075 Pilot System; refer to chapter
2.5 of this manual.
Ordering information for applicable hardware:
Z510320030 Stirrer controller module P100 - P310,
Z510320040 Stirrer controller module P1000,
Z510320050 Stirrer controller module for motors top/bottom 7 Nm,
Z510320060 Stirrer controller module for motors bottom 24 Nm,
Z5100002M0 Stirrer motor assembly P100 (top),
Z5100002M1 Stirrer motor assembly P140 (top),
Z5100002M3 Stirrer motor assembly P310 (top),
Z5100P1000
Stirrer motor assembly P1000 (top),
Z510000001 Stirrer motor assembly P100 I=6 (top),
Z510000002 Stirrer motor assembly P140 I=2 (top),
Z5100P1005 Stirrer motor assembly P1000 I=5 (top),
Z5100B1000 Stirrer motor assembly P1000 (bottom),
Z51000BT07 Stirrer motor assembly 7 Nm (top),
Z51000BB07 Stirrer motor assembly 7 Nm (bottom),
Z51000BB24 Stirrer motor assembly 24 Nm (bottom),
Z510121C03 Cable for motor P100 - P1000 ADI 1075,
Z510121C04 Cable for motor BB/BT 7 Nm ADI 1075,
Z510121C05 Cable for motor BB 24 Nm ADI 1075,
Z510120000 Re-calibration of stirrer speed controller (required calibration range must be
specified).