Applikon ADI 1075, Installation/Hardware Manual, Page: 14 / 31

INSTALLATION AND HARDWARE MANUAL
ADI 1075 Pilot System
BASIC UNIT
December 2002
2-9
Fuses:
Internally - behind the rear panel - a number of fuses can be found. See the image below:
Fuses F21 through F23 are used for the applied stirrer motor and are described in the manual
of the ADI 1032 stirrer speed controller.
The fuses for the internal power supply are described on next page!
Note: All applied fuses must comply with IEC 127!
Fuses F1 through F3 are main fuses for the three separate live circuits,
Fuse F4 = Fuse for “Power-On” circuit,
Fuse F5 = Fuse for “Unswitched Power Supply” (for Control Device),
Fuse F6 = Fuse for “Switched Power Supply” (for Actuator Devices),
Fuse F7 = Fuse for the Lifting Device / Level Sensor Circuit
Fuse F11 = Fuse of Heating Circuit 1 (Temp. Section / Wet part),
Fuse F12 = Fuse of Heating Circuit 2 (Temp. Section / Wet part),
Fuse F13 = Fuse of Heating Circuit 3 (Temp. Section / Wet part),
Fuse F31 = Fuse for “Thermal Cut-off” (Temp. Section / Wet Part),
Specification of fuses F1 through F31 (F21 through F23 are excluded):
F1 . . F3
Ceramic Bus Type 110/120Vac: 20A 230Vac: 10A
F4 5 x 20 mm 110/120Vac: T 1A 230Vac: T 0.5A
F5 5 x 20 mm 110/120Vac: T 2A 230Vac: T 1A
F6 5 x 20 mm 110/120Vac: T 1.6A 230Vac: T 0.8A
F7 (lift control) 5 x 20 mm 230Vac: T 1.6A
F7 (level) 5 x 20 mm 110/120Vac: T 2A 230Vac: T 1A
F11 . . F13 5 x 20 mm 110/120Vac: T 10A 230Vac: T 5A
F31 (24Vdc) 5 x 20 mm T 0.5A
Note:
In case the main supply voltage is 200V3~ (115Vac) and electric head plate lifting is
applied, fuse holder F8 also contains T 1.6A!