AP Expert VT-110, User Manual

Page: 63 / 84

Chapter 15: Relative Humidity Compensation
Min Vent Comp % Select by how much to increase the fan speed above the minimum fan
speed when the RH level if 10% above the RH Set Point. *Accessible if
RH compensation on minimum ventilation is enabled.
RH Set Point This is the humidity level above which high RH compensation functions
start. Adjustable from 20 to 99% of humidity.
Heater Compensation The timer used by heating outputs is made of an On Time and of a
Cycle Time. Heating outputs run during the On Time then stop until the
end of the Cycle Time. The On Time portion of this cycle increases as
RH levels increase.
Minimum & Maximum On Times Set the minimum and maximum On Times of the heating timer. The
minimum On Time starts being used when indoor humidity levels reach
the RH set point; the maximum On Time is used when humidity levels
are 10% above the RH set point. *Accessible if RH compensation with
heating outputs is enabled.
Cycle Time Set the cycle time of the heating timer. *Accessible if RH compensation
with heating outputs is enabled.
Mist Shutoff Set the humidity level above which the mist cooling output stops or
select “Off” to disable this function. *Accessible if the mist shutoff com-
pensation option is enabled.
Mist on Low RH Lo Set Point Set the humidity level below which misting units start running in timer
mode or select “Off” to disable this function. *Accessible if RH comp.
on Low RH levels is enabled.
On & Off Times Set the On and Off Times of the misting timer.
890-00081 Expert VT-110 63