AP Expert VT-110, User Manual

Page: 25 / 84

Chapter 6: Relay Assignment
It is possible to assign the same relays to the cooling and soaking outputs. In this case, the relays switch
whenever one of the two outputs is activated.
1. Using the menu select arrow keys, navigate to Relay Settings→Cooling .
NOTE: This menu is accessible if the cooling output relay is enabled.
2. Put a checkmark beneath the relay used by the cooling output relay.
Assigning Soaking Output Relays
What You Should Know
It is possible to assign the same relays to the cooling and soaking outputs. In this case, the relays switch
whenever one of the two outputs is activated.
1. Using the menu select arrow keys, navigate to Relay Settings→Soaking .
NOTE: This menu is accessible if the soaking output is enabled.
2. Put a checkmark beneath the relay used by the soaking output relay.
Assigning Clock Output Relays
1. Using the menu select arrow keys, navigate to Relay Settings→Clock Output , and then select the
desired clock.
NOTE: This menu is accessible if a clock output is enabled.
2. Put a checkmark next to the relays used by the clock output relay.
Assigning Backup Relay Box
When you assign a relay to the backup relay box, this normally closed relay opens when a controller or
power failure occurs.
1. Using the menu select arrow keys, navigate to Relay Settings→Backup .
NOTE: This menu is accessible if a backup relay is enabled.
2. Put a checkmark beneath the relays used by the backup box.
Assigning Brooder Heater Relay
1. Using the menu select arrow keys, navigate to Relay Settings→Brooder .
NOTE: This menu is accessible if a brooder heater that uses the relay mode is enabled.
2. Put a checkmark beneath the relay used by the brooder heater.
890-00081 Expert VT-110 25