AP Expert VT-110, User Manual

Page: 23 / 84

6
Relay Assignment
Topics Covered in this Chapter
▪ Relay Assignment
▪ Assigning Heater Relays
▪ Assigning Fan Stage Relays
▪ Assigning Tunnel Curtain Relays
▪ Assigning Inlet Relays
▪ Assigning Stir Fan Relays
▪ Assigning Cooling Output Relays
▪ Assigning Soaking Output Relays
▪ Assigning Clock Output Relays
▪ Assigning Backup Relay Box
▪ Assigning Brooder Heater Relay
Relay Assignment
The controller can control up to 10 on/off relay outputs and two variable outputs. You must determine the
mapping between the stages and the relays.
NOTE: Note that relay assignment can only be made by the installer. A password is required to access
this menu.
The relays with a mark below are assigned to the selected output. Use the up and down arrow keys to
scroll the display. The first number above the relay numbers stands as the first number of the relay.
Pressing the down-arrow key directly goes to the last relay and pressing the up-arrow key returns to the
first relay. This makes it easier to step through the relays.
A template is available at the end of this manual to write down your selection of relays.
Assigning Heater Relays
1. Using the menu select arrow keys, navigate to Relay Settings→Heaters .
2. Put a checkmark beneath the relays used by the selected heating stage.
3. Repeat step 2 to assign relays to each heater and heater hi in use.
Assigning Fan Stage Relays
1. Using the menu select arrow keys, navigate to Relay Settings→Fan Stages , and then select the
desired fan stage.
2. Put a checkmark next to the relays used in the selected fan stage.
NOTE: Only select fans in the fan section. Other items are assigned in other sections.
890-00081 Expert VT-110 23