AP Expert VT-110, User Manual

Page: 58 / 84

Chapter 14: Outputs
Setting the Brooder 0-10V Start and Stop Temperatures
1. Using the menu select arrow keys, navigate to Start / Stop Temps→Brooders→Settings .
This menu is accessible if the brooder output is enabled.
2. Set the following parameters:
Start temperature Set the temperature above which the brooder
heater starts running at minimum intensity. *This
parameter cannot be modified if the brooder curve is
on.
Stop temperature Set the temperature over which the brooder heater
turns off.
Differential Select at how many degrees below the Start Tem-
perature the brooder heater reaches its maximum
intensity. *This parameter is accessible if the
brooder mode is set to 0-10V in the installation
menu
Minimum output Set the minimum intensity of the brooder heater (in
%). *This parameter is accessible if the brooder
mode is set to 0-10V in the installation menu.
Maximum output Set the maximum intensity of the brooder heater (in
%).*This parameter is accessible if the brooder
mode is set to 0-10V in the installation menu.
Clock Outputs: How it Works
The controller has 2 outputs to control various devices using the real-time clock. These clock output can
use up to 24 timer cycles.
A clock output starts when the “On Time” of a timer is reached; it either stops after a certain run time or at
a certain time of day.
The following diagrams show both possibilities:
58 890-00081 Expert VT-110