26
9.5 How to Load Printer Paper
• Open the paper compartment by lifting the catch located at the rear of the terminal
and pull the cover to the rear of the terminal
• Insert the paper roll (diameter 40mm) in the compartment and following the directions
shown on the picture
• Pull the paper up to the top of the terminal and hold in position
• Maintain the paper roll position and close the lid
• Press the top of the lid in the centre until it clips into position.
Lift catch up
Pull cover open
Correct paper
position
NOTE:
Do not tamper with or remove the terminal housing.
9.6 Battery
The ANZ POS Mobile Plus terminal battery that will allow approximately 500 basic
Transactions to be completed with one fully charged battery. A full charge of the battery
will take up to 4 hours to complete.
When does the battery need to be charged
• On initial start up, it is important to charge the battery for 16 hours
• Before commencing a shift, please make sure to fully charge the battery to ensure the
maximum number of transactions can be completed
• When used daily, the terminal recharges its batteries each time it is placed on its base
if base power supply is connected to the main power outlet on the wall.
