Bitek Technology
ANYTRON ANYCUT1 User Manual
© 2016 Bitek Technology. All rights reserved.
User Document
Rev 1.0.0 – 2016.03.06
58 of 120
⑦ Vision Wait Time: If the next black mark does not come within the Vision wait Time is set
in Beamcut, 'Vision Time Out' error message can be generated. Now, for Anycut, it is using 5
~ 10sec generally for Vision Wait Time.
<Vision Time out error>
⑧ Cutting Pos: It is a position to start cutting. now, in Beamcut, if Stop and Go is set as a
cutting mode and it is set as 0 automatically. also, if On the fly is set as a cutting mode and
it is set as 105mm automatically, too. By the way, in case of Stop and Go, the start position to
cut is outskirts, not center. so, the waste paper removal is hard compared the center and user
change the cuting position to make it be closer at the center. Then, user can use a stronger
laser like On the fly. At this time, a user should be noted that the operation may proceed to
a split cut depending on the page legnth and Cutting position.
< The cutting position depends on the cutting mode>
PART Ⅴ