Bitek Technology
ANYTRON ANYCUT1 User Manual
© 2016 Bitek Technology. All rights reserved.
User Document
Rev 1.0.0 – 2016.03.06
20 of 120
※
If you experience any one of the above, you should tune the sensor again.
※ Please refer to this manual 17p,'Black Mark Sensor Tuning'
-
How to use Rear Sensor
1
User can use the rear sensor by using
the swtich that is isntalled in the left
side wall of the machine.
2
The rear sensor is installed at the
bottom like a picture. It can be used
to tune in the same manner as in
conventional sensors.
3.1.3
How to Set Vision Camera
Vision camera is used to correct an error caused by a number of factors such as the contraction of the
paper according to the mechanical error, the printing error of the fusing temperature during printng. Also,
Vision camera doesn't find a cutting position by itselves, it corrects the printing error based on the
information you have saved Mark vision through vision.
※ Service environment for Vision Camera