Bitek Technology
ANYTRON ANYCUT1 User Manual
© 2016 Bitek Technology. All rights reserved.
User Document
Rev 1.0.0 – 2016.03.06
32 of 120
※ Generally, Bitek Technology recommend users use default value about all parameter settings, except
Mark speed
③ Jump Speed: The speed that laser moves to the next cutting line
In Anycut, it uses 500 to 700 values.
④ Frequency: The frequency sent during cutting (Delivered Frequency)
In Anycut, it uses 10,000Hz for the paper, 7000Hz for Film.
PARTⅡ
PARTⅡ is consisted of Delay contorl menu to make a better cutting quality.
When the laser On or off or before/after laser on or off, Laser Delay affect the Mark command. 또한
Except if the laser is abnormal and does not affect the overall Laser Marking time. But beacause he
time to start to cut can be late, it can affect the overall time to work time and user can refer to
examples as below to control the delay depends on the case.
① Jump Delay
-
When Jume Delay is too short (Example 1)
when Jump Delay is too short, the laser starts to mark after jumping faster than time to marking
actually and it looks like abnormal makring shape like wave. It means that laser starts to work before
the laser arrives that the area started marking. In this case, it can cause problems as below.
<Example 1>
-
When Jump Delay is too long
even if Jump Delay is set too long, it does not affect the cutting quality, but the overall working
time can be long.