47
FUNCTION MENU SETUP
Battery Save Setup
You can set a battery save ratio according to your requirements. The standby
time can be extended if you enable the battery save function, but if you set the
ratio setting too high, it may cause you to miss the beginning of a transmission.
When the transceiver receives a matching signal or make start an operation it will
automatically exit this function.
1. Press
key, the top left corner of the LCD will display " " icon, then press
key to enter into function menu.
2. Press
/
key to choose NO. 29 function item, it shows "
SAVE
" on LCD.
3. Press
key to enter next menu, press
/
key to choose desired setting.
OFF:
Battery Save is disabled.
1:2
The standby time between the normal working state and battery saving mode is 1:2
1:3
The standby time between the normal working state and battery saving mode is 1:3
1:5
The standby time between the normal working state and battery saving mode is 1:5
1:8
The standby time between the normal working state and battery saving mode is 1:8
AUTO:
The battery save ratio is adjusted automatically.
4. Press
key or
key to confirm and exit.
1750HZ
,
2100HZ
,
1450HZ
,
1000HZ
- These are the 4 settings you can set as required by your local
repeater.
4. Press
key or
key to confirm and exit.
Suggestion: If you use your radio in a single band set-up (UHF or VHF ), the recommended setup is 1:8. If you
use your radio in a dual band set-up (UHF and VHF), the recommended setup is 1:2.
