26
BASIC OPERATIONS
▼
▼
▼
▼
▼
NOTE:
Frequency scan will go through all bands, it will scan upwards in increments that you have set the STEP setting to.
In channel scan, skipped channels will not be scanned. It will scan upwards through channels. (please refer to
channel scan skip).
Frequency/channel scan can change the scanning direction by pressing
/
, If a signal is found the
transceiver will stay 5 seconds then continue scanning. (Please refer to scan setup)
Frequency scan can be limited to UHF / VHF if you have the single band mode enabled (See: Function Menu -
Single Band Mode (VHF/UHF)
Frequency Scan can also be limited to your pre-set scanning border limits (See: Limit VFO frequency scanning
range)
Frequency/Channel Scan
Under the corresponding mode, press
key, the top left corner of the LCD will
display "
" icon, then press
key to start frequency scan or channel scan.
Under VFO mode, frequency scanning is available. The frequencies will be scanned
by the transceiver's ‘step’ setup, press any numeric
key or key to exit.
Under channel mode, channel scanning is available. The channels will be scanned in order of the channel setup
as long as they are not programmed to "Skip" during scanning, Press numeric key or
key to exit.
1. Frequency Scan
2. Channel Scan
