25
Offset Frequency Direction Setup
BASIC OPERATIONS
When in standby, press
key, the top left corner of the LCD will display " " icon, then press
key to choose offset frequency direction. There are 3 options, Plus offset, Minus offset, remove offset.
NOTE:
This function is will not work when the transceiver is set up in professional mode or the current selected
channel does not have any CTCSS/DCS signal first set up.
If your current channel has its tone signaling set as CTCSS, it will scan CTCSS, if its tone signaling is set as
DCS, it will scan DCS.
(+) Plus offset: Indicates that the TX frequency is higher than the RX frequency.
1.
If the reverse function is enabled, the RX frequency is higher than TX frequency.
(-) Minus offset: Indicates that the TX frequency is lower than the RX frequency.
2.
If the reverse function is enabled, the RX frequency is lower than TX frequency.
None: Indicates that the offset is off.
3.
Under frequency mode (VFO) or channel mode, press
key then press
key to choose: plus offset
dir), minus offset direction (-), or remove offset (Please refer to offset frequency setup).
key to enter into CTCSS/DCS scan. Under this state, press
/
to
change the scanning direction. When the scan receives CTCSS/DCS signaling, it
will stay 5seconds and then continue scanning. Press any other keys except
,
, key to exit.
