Antec Scientific ROXY Exceed, User Manual, Page: 61 / 126

Chapter 5 Operation modes & Parameters 61
Table IV. DC mode filter setting and corresponding data rate.
Filter setting DC mode (Hz) Data rate (Hz)
RAW 100(default), 50, 20, 10, 5, 2, 1
10 100
5 50
2, 1 20
OFF 10
0.5, 0.2, 0.1 10
0.05 5
0.02 2
0.01, 0.005, 0.002, 0.001 1
Filter OFF is also a special case. The data rate is fixed to 10 Hz, and the
data is not filtered. Setting OFF is therefore the same as RAW at 10 Hz.
Pulse mode
In the pulse mode the working electrode is dynamically and continuously
regenerated by a series of potential steps in a cyclic manner. Data is pro-
cessed differently, and the data rate is defined by the total duration of the 5
potential steps in a pulse: t1 + t2 + t3 + t4 + t5. Usually the typical pulse
duration is between 0.5 and 2s (data rate between 2
– 0.5 Hz). Filter set-
tings in the pulse mode are therefore selectable between 0.5 and 0.001
Hz, and OFF. In Pulse mode 2 filter settings in the range of 0.5 and 0.01
Hz are selectable.
The scan mode has no filter at all.