Antec Scientific ROXY Exceed, User Manual, Page: 25 / 126

CHAPTER 2 Installation 25
With both hands under the instrument lift the potentiostat to its operation
location. Install the potentiostat in an area which meets the environmental
conditions.
Fig. 2. Location of ventilation holes in the ROXY Exceed (bottom & rear).
Remove the protective tape from the ROXY Exceed LCD screen. Leave
the instrument to adopt ambient temperature for at least half an hour in the
place of installation.
Use the potentiostat indoors only. Place the potentiostat upright (on its
instrument feet) on a stable, flat and smooth surface. Do not place the
instrument in an area subject to excessive dust or shocks.
Do not place it near a source of heat or in direct sun light, as this may
influence the heating capabilities of the instrument. Make sure the
potentiostat is placed in such a way that the mains power connection
can be reached easily to disconnect it from the mains power by
removing the Mains power cable. Do not block the ventilation holes at
the back and bottom of the instrument (Fig. 2.). Blocking might impair
the cooling capability of the power supply.
Do not place heavy object/instruments on top of the potentiostat. Objects
can be placed on any side of the potentiostat; however, make sure these
objects are placed at a distance of 5 cm from the potentiostat, in case that
objects are placed at only one side of the instrument. and 10 cm from the
instrument, if objects are placed on both sides of the instrument.