Antec Scientific ROXY Exceed, User Manual, Page: 107 / 126

CHAPTER 9 Rear panel I/O 107
Programming outputs
In the Dialogue Elite software the ROXY Exceed outputs (Relays and
AUX) can be controlled and programmed. This can be done via the Poten-
tiostat tab on the main window and via timed event tables. By default the
I/O is hidden and not shown in the monitor tab. To be able to see the sta-
tus and control buttons for the I/O go to the Device settings window (set-
tings tab)
and check the ‘Show status outputs’ checkbox under the controls
section.
Fig. 54. Dialogue Exceed Potentiostat tab with I/O status and control but-
tons (check boxes).
The status of the Relays and TTL inputs can be set to active (

) or inac-
tive (

). The selected state of the outputs will be activated after clicking
the ‘Send to device button’.
The outputs can also be switched via timed events under the events tab.
By opening a ‘New event’ under the Events pull-down menu, a new Event
table/file can be created. Subsequently, the Event editor will open. Select
the event ‘Output A’ and assign a time at which the output should be
switched and select which output should be activated (Relay, Aux) under