ANITA ©
GPS/G serie
24
13. X-Y X-Y origin setting
A. X-axis origin setting
a)Remove the X-cover of lower feed plate.
Move the upper feed plate along X-axis to keep it pointing to the center.
b) As the figure shows, loosen the two screw on the detecting sensor holder, locate the origin
detecting plate of X-axis in the centre of the sensor. Then tighten it with a cross screw driver.
Fig. 40
B.Y-axis origin setting
a)Remove the cover of Y- step motor..
b)Move the upper feed plate along Y-axis
c)Loosen the set screw as the figure shows, to locate the origin detecting plate of Y-axis in the
center of the origin detecting sensor, then tighten it with a L-type wrench.
www.garudan.cz
