ANITA ©
GPS/G serie
17
Fig. 22
C. Adjust the press-feed adjust pole
a) Loose position connect (plug ) board screw , make some distance between position connect
board (4) and press-feet connect fix screw (3) .
b) Loose screw (1), move the press-feet connect screw(2) to the right side of adjust pole, and
then fix the press-feet connect screw(2) .
c) Turn the handle block, make the needle shelf to the lowers position
d) Move up the press shelf ,make sure the distance between press shelf and press shelf
bushing is about 4mm, and fix the screw(1).
Fig. 23
D. Adjust the distance of press-feet.
L
oosen press-feet adjust pole screw (1)along A
position move ,the distance of press-feet could
increase , along B position move , the distance could
reduce.(the distance is 4mm when leave factory )
Fig. 24
www.garudan.cz
