ANITA ©
GPS/G serie
22
a) Be sure do not run cut-thread parts ,
loose the screw of cut-thread drive
determent-organ , adjust clearance to
0.3mm between cut-thread drive and the
concave of cut-thread drive determent-
organ .
b) (47)Screw fixed screw tightly.
[Notice] If the chosen position is not
exact, it may be occur cut-thread badness
or machine locked.
Fig. 34
E. Adjusting the position of thread cutting tube
a) Steed screw of thread solenoid bracket will adjust the distance to 0.5mm between cut
thread, and then tighten the screw.
b)Loose the steed screw of cut thread solenoid circumrotate link, use hand to turn the cut
thread solenoid circumrotate link and move the core axis loop according to arrow head
direction.
c)When cut thread solenoid circumrotate link come back,
[Notice]
If the position is not proper,
it could occur the speed
becomes to reduce, let
sewing effect no well.
Fig. 35
F. Adjusting the movable knife and the fixed knife
a). When needle board stops upside, the following data by movable knife and needle board
hole distance A use cut thread pole adjust part.
b)Use fixed knife screw to adjust the distance to following data between needle board cover
and fixed knife.
c)After adjustment, ensure the cutter position by running the thread cutting device manually.
[Notice] If the position is not
proper, thread cutting failure
occurs or there will be less
thread end left.
Fig. 36
www.garudan.cz
