ANITA ©
GPS/G serie
13
8. Adjusting pressure foot height
A.
Loosen Screw 1
Keep a height gap of 0.5mm between the
pressure foot low tip and the sewing
material, then tighten Screw
[Notice]
After adjusting the height of pressure foot,
the treadle position should be ensured.
If too large a distance, the treadle will
spring up.
If too small a distance, disoperation will
occur.
Fig. 13
9. Used oil disposal
The oil container attached under the
worktable should be taken away for
cleanup after it is full of oil.
[Notice]
While the oil container is taken away,
possibly oil will spray on the ground, so
please place paper or its like on the
ground for this purpose.
(34)
Fig. 14
www.garudan.cz
