ANITA ©
GPS/G serie
15
Fig.17
3. Adjusting bottom shaft gear and swing gear
A. Loosen Screw 1 and 2.
B. While rotating the upper shaft, turn the eccentric in the direction shown by the arrow to
adjust the gear drive position.
[Notice]
When the swing gear is not positioned accurately, the machine will not run.
C. After surge organ axis loop (right) keep close to desk (A), tighten the screws.
D. After surge organ axis loop (right) keep close to desk (A) eddy according to arrowhead, let
the top of shuttle have 0.1mm clearance and could eddy easily.
[Notice]
If the clearance is too large between gear teeth, the machine will make increasing noise, and if
too small, it will not be started.
E. Fastening screw
①
Fig.18
4. Adjusting the shuttle spring position
A.
Separate the low feed plate, loosen the top
screw of the spring, align Back point (A)
vertically, and adjust the spring to keep it in
line with the center (B) of needle, then
tighten the screw.
Fig.19
www.garudan.cz
