- 17 -
3269870_ut_GB_rev.2
ENGLISH
GB
FAULT
TROUBLESHOOTING
The appliance has been tested before being
put into service.
The information provided below is intended
to assist in the identifi cation and correction of
any anomalies and malfunctions which might
occur during use.
The user can solve some of these problems
himself, but for others specifi c technical
knowledge or skill is required, and so they
must only be carried out by qualifi ed staff with
recognised experience acquired in the specifi c
sector of operation.
Important
For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Fault
Causes
Remedies
Smell of gas.
Occasional leak because
fl ame has gone out.
Turn off the gas supply tap and
ventilate the room.
The fl ame is yellow.
Burner dirty, heat exchange
pipes clogged, condensation
drips.
Importante
Important
Contact the after-sales service.
The appliance does not heat
up.
Check the thermostat and activate
any start-up enabling device.
Contactor not receiving
power or faulty.
Check or replace the contactor coil..
The control panel does not
come on.
Electronic circuit board not
receiving electrical power.
Check or swap the phase wire
connections.
