Anest Iwata MSU-111N, Instruction Manual

Page: 15 / 40

- 13 -
Ű 5. Operation
5-2. Preparing for spraying
IMPORTANT
1. Always fully close or fully open the circulation valve. Opening the valve halfway can cause seat wear, fluid
leakage and lack of fluid pressure.
Refer to Fig.1 on page 8 or Fig.2 on page 9 to find reference letters.
1. Remove air cap set and nozzle tip from spray gun.
2. Close
Air Regulators (C and F) fully.
3. Open Circulation Valve (G).
4. Set Emergency Valve (D) to “ Operating ” position.
5. Put Suction Hose Set (E) and Circulation Tube (H) into fluid container.
6. Adjust Air Regulator (C) to 22 - 73psi (0.15 - 0.5MPa, 1.5 - 5bar) slowly.
7. Circulate fluid through Circulation Tube (H) until fluid does not contain bubbles.
8. Point spray gun toward to container and pull trigger of spray gun. Be sure that compressed air is not supplied
to the spray gun before pulling the trigger.
9. Close Circulation Valve (G).
10. Circulate fluid through the spray gun until fluid does not contain bubbles.
11. Release the trigger of spray gun.
5-3. Spraying
IMPORTANT
1. See spray gun instruction manual for spray gun operation.
HINT
1. Half fill compatible solvent into wet cup to increase pump life.
Refer to Fig.1 on page 8 or Fig.2 on page 9 to find reference letters.
1. Place specified nozzle tip on spray gun.
2. Adjust
Air Regulators (C and F) to specified pressure.
3. Start spraying.
5-4. Emergency stop
Refer to Fig.1 on page 8 or Fig.2 on page 9 to find reference letters.
1. Set Emergency Valve (D) to “ Emergency Stop ” position and open Circulation Valve (G).
5-5. Stopping operation
HINT
1. Position plunger pump at the end of down stroke to increase pump life when not in use.
Refer to Fig.1 on page 8 or Fig.2 on page 9 to find reference letters.
1. Close Air Regulators (C and G) fully.
2. Open Circulation Valve (G) slowly and pull the trigger of the spray gun. Make sure fluid and air pressure are
at “ 0 ”.