AN-Motors ASG1000/3KIT, Installation And Operation Manual

Page: 12 / 23

12
5.5. Drive connection to the electric network
During the first connection of the drive to the electric network:
Make sure that the rail carriage is blocked.
Connect the plug of the drive feeding cable with the outlet of supply network.
Immediately after connection of the plug and the outlet there will be a short light from the
lamp (lightening), the indicator on the drive control panel (Pic. 5) will show the numbers
from «99» to «11». Then the drive will switch to the sleeping mode (the indicator will show
«--»). If the indicator does not show the symbol switch off the drive from the network and
carefully examine all connections (see he part «Malfunctions and recommendations on their
elimination»).
If the drive is connected with photo cells it is necessary to check the receiver (RX). If the
indicator of the receiver blinks or does not glow it means that there is no signal of it is in-
terrupted due to inaccurate adjustment of the photo cells. The option of photo cells applica-
tion must be activated beforehand (see part «Adjustment»).
6. Adjustment
Drive adjustment is performed through the control panel (Pic. 5) which has four buttons and
an indicator (double 7-segment indicator).
CODE SET
UP DOWN
Pic. 5. Control panel
Table 4. Functions of buttons on the control panel
Button Function
SET
Choice and confirmation of the function
UP
Increase of the parameter during programming and ad-
justment; controls the doors opening while adjustment of
final positions
DOWN
decrease of the parameter during programming and ad-
justment; controls the doors closing while adjustment of
final positions
CODE
Programming and deleting of the radio control panel
6.1. Adjustment of final positions
Adjustment of final positions of door opening/closing is performed manually (Table 5).