AN-Motors ASG1000/3KIT, Installation And Operation Manual

Page: 11 / 23

11
-
+
BAT
-
+
+24V PE GND PB
C
O
M
N
O
-
+
-
+
C
O
M
N
C
RX
TX
фотоэлементы
кнопка
управления
аккумулятор
Pic. 4. Electric supply system
5.1. Photo cells installation
To ensure the security the drive may have photo cells. Output circuit of the receiver (RX) must
be connected with the terminals «PE»
and «GND». Power circuit of the receiver (RX) and
transmitter (TX) of photo cells are connected with the terminals «+24V» and «GND».
If there are several pairs of photo cells they must be connected one with another consecutively
in the output circuit and parallel in the power circuit.
When the doors are closing photo cells interrupt their movement and initiate further opening of
the doors.
5.2. Control buttons installation
To control the drive in the step-by-step mode (corresponds to the sequence …Open – Stop –
Close – Stop…) there is a possibility to connect devices with “normally open contacts”: buttons,
locking switches, etc.
Connection of the control button (or buttons) is performed to the terminals «PB» and «GND».
If there are several buttons installed to control the drive, they must be connected parallelly.
Control devices must be positioned within sight of the doors at a safe distance from the mova-
ble parts at a height not less than 1,5m.
5.3. Other devices installation
The drive can be also connected with other devices, for example, universal receiver of radio
control, etc. These devices can be connected with the terminals «+24V» and «GND» with volt-
age 24В of direct current. Maximum level of current for all devices connected with the termi-
nals «+24V» and «GND» must not exceed 100mA.
5.4. Accumulator installation
Accumulator (accumulating battery) can be used as a standby power supply source with
24В/2,5А·h. The drive control panel automatically switches to the accumulator in case of ab-
sence of the mail power supply and automatically returns to the mail power supply when it
starts functioning. The drive control panel controls the battery charge.
!
If the connection of additional devices (for example accumulator) is performed after
commissioning of the drive system re-program the final positions of the doors (see
part «
A
djustment of final positions») and check the drive system functioning.
Photo cells
Control button
Accumulator