AN-Motors ASG1000/3KIT, Installation And Operation Manual

Page: 13 / 23

13
Table 5. Adjustment of final positions of door opening/closing
Action Indicator
1
Press and hold button «SET» for 5 seconds
2
When you see the indicator
«Р1» release the button and press once again
«SET» without holding it
3
When you see the indicator
«ОР» using buttons «UP» and «DOWN»
move the door leaf to the final opening position. Then press the button
«SET»
4
When you see the indicator
«CL» using buttons «UP» and «DOWN»
move the door leaf to the final closing position. Then press the button
«SET»
5
The doors will automatically open and close to fix two final positions and
force applied to move the doors in the control unit memory.
6
When the positioning is over the drive will be adjusted in the waiting mode
!
The process of programming must not be interrupted. If it happens all actions must be
repeated from the beginning.
6.2. Adjustment of working modes
Control unit allows to adjust the following parameters of the drive (table 6): power, mode of
operation of photo elements, auto-closing and electronic interlock.
The adjustment of power (А, table 6) allows to define the level of power while closing the
doors. When this level of power is achieved the drive stops and opens the doors in case there
is an accidental obstacle (for example, a vehicle or a man).
The adjustment of photo elements (В, table 6) allows to activate the drive during the function-
ing of photo elements.
The adjustment of auto-closing (С, table 6) ensures the automated closing of the doors when a
definite period of time after the opening expires.
Electronic blocking (D, table 6) is used to avoid the opening of the doors in case of random
pressing on the buttons. If this function is active, at first it is necessary to press briefly the
button «В» on the control panel (pic. 6), then press the button programmed to control the
drive.
Table 6. Adjustment of the drive
Adjustment / Action Indicator
A) Adjustment of power -
1
Press and hold button «SET» for 5 seconds
2
When you see the indicator
«Р1» release button «SET»
3
Press button
«UP». When you see the indicator «Р2» press button «SET»
4
Press button
«UP», to increase the power by one point, button «DOWN»,
to decrease the power by one point. Maximal level
«F9», minimal - «F1».
Factory setting-
«F5».
…
5
To confirm the chosen value press button
«SET», after that the drive will
be adjusted in the waiting mode.
B) Adjustment of photo elements -