10
Position the fixing bracket of the rail 12 (view F, Pic. 2) and the bent fixing strip 22 (de-
scribed above) on the rail at a place ensuring the highest rigidity of the rail (for example, at
a distance 1/3 of the rail length from the door passage). Connect the fixing bracket of the
rail and the fixing strip using two bolts 14 and two nuts 18.
Using the ladder lift the rail with the drive so that the bent strips are pressed to the ceiling.
Level the rail vertically and horizontally (is checked with the level). Mark four points for the
dowels to adjust the rail to the ceiling.
Adjust the dowels and fix the strips 22 to the ceiling. Use the dowels suitable for the mate-
rial and wall thickness.
!
Fixing elements must hold the rail weight with the drive and resist the effort required
for opening / closing of the doors. Take into account the objective wear and defor-
mations.
4.5. Connection of carriage and door curtain
To connect the carriage of the rail and door curtain (view G, Pic. 2) follow the instruction:
Connect the cranked rod 6 and forward thrust 7 using two bolts 14 and two nuts 18 regu-
lating the common length by choosing the appropriate apertures
Using axes 19 and cotters 20 fix one end of combined rod on the carriage, adjust the door
bracket 11 at the other end.
Move the combined rod together with the carriage (first unblock the carriage) until the door
bracket 11 touches the top end of the door curtain. Then level the rod and fix it on the
doors using four self-tapping screws 16.
5. ELECTRIC SUPPLY SYSTEM
!
Before starting the connection works make sure that the wiring is cut off.
!
During operation and installation of electrical devices (accessories) it is obligatory to
follow the present manual. Incorrect connection may fail the functioning of the drive.
After installation of electrical devices it is necessary to connect them with the drive. Follow the
instruction:
Turn off four screws, remove the frame cover of the drive to open the access to the termi-
nals of the control panel.
Using the drill make an aperture in the frame base, it is needed for laying cables from elec-
tric devices to the control panel.
Using the screwdriver connect the electric conductors to the terminals of the drive control
panel (Pic. 4) according to points 5.1 … 5.4.
Summary of Contents for ASG1000/3KIT
Page 22: ...22 Notes...
Page 23: ...23 Notes...