AMX Vision 2, Operation/Reference Manual

Page: 34 / 128

Installation
24 Vision
2
Operation/Reference Guide
The following steps show you how to setup a typical configuration for the Dealer Demo Systems.
1.
Connect the power supply to the rear of the Dealer Demo server.
2.
Connect an RJ-45 LAN cable to LAN port one on the back of the Dealer Demo server. See FIG. 13 and
FIG. 14 for connection locations for each type of Dealer Demo server. Connect the other end of the cable
to a Gigabit port on a layer 3 network switch.
FIG. 13 displays the connection locations for the VS-DLR-DEMO-SFF server.
FIG. 14 displays the connection locations for the VS-DLR-DEMO-1RU server.
3.
Connect an RJ-45 LAN cable to the Ethernet port on your encoder. Connect the other end of the cables to
any of the ports on your network switch.
4.
Connect a composite or S-video cable to the corresponding ports on your encoder. Connect the other end
of the cables to a device capable of producing a video signal. The encoder converts the video signals into
MPEG-2 multicast streams.
Vision
2
uses typical Cat5/5e/6 cabling for RJ-45 connections.
FIG. 13 V2-DLR-DEMO-SFF Dealer Demo Server (rear-view)
LAN port
The V2-DLR-DEMO-SFF system only has one RJ-45 LAN connection.
FIG. 14 V2-DLR-DEMO-1RU Dealer Demo Server (rear-view)
To CLIENT-SIDE LAN
To VIDEO LAN