Programming
72
Enova DVX-2100HD 6x2 All-in-One Presentation Switcher Operation/Reference Guide
Audio SEND_COMMANDs (Cont.)
?AUDMIC_ON
Requests the status of the
microphone.
Queries to see if the microphone addressed by the D:P:S is on.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_ON'"
Example:
SEND_COMMAND MIC_1,"'?AUDMIC_ON'"
Returns a COMMAND string of the form:
AUDMIC_ON-<ENABLED|DISABLED>.
AUDMIC_ON
Turns on or turns off the
microphone.
Enables or disables whether the microphone addressed by D:P:S is on.
Syntax:
SEND_COMMAND <DEV>,"'AUDMIC_ON-<ENABLE|DISABLE>'"
Example:
SEND_COMMAND MIC_1,"'AUDMIC_ON-ENABLE'"
?AUDMIC_PREAMP_GAIN
Requests the pre-amplifier
gain setting on the
microphone.
Queries the pre-amplifier gain of the microphone addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_PREAMP_GAIN'"
Example:
SEND_COMMAND MIC_1,"'?AUDMIC_PREAMP_GAIN'"
Returns a COMMAND string of the form: AUDMIC_PREAMP_GAIN-<value>.
AUDMIC_PREAMP_GAIN
Sets the pre-amplifier gain
on the microphone.
Sets the pre-amplifier gain of the microphone addressed by the D:P:S to
<value>.
Syntax:
SEND_COMMAND <DEV>, "'AUDMIC_PREAMP_GAIN <value>'"
Variables:
value = 0-63. The units are in dB
Example:
SEND_COMMAND MIC_1,"'AUDMIC_PREAMP_GAIN 50'"
Sets the pre-amplifier gain of microphone #1 (based on D:P:S, where P=7) to
50.
?AUDMIC_STEREO
Requests the status of
single stereo mode on the
microphone.
Queries to see if two MIC input channels are set in single stereo mode
addressed by the D:P:S.
Syntax:
SEND_COMMAND <DEV>, "'?AUDMIC_STEREO'"
Example:
SEND_COMMAND <DEV>,"'?AUDMIC_STEREO'"
Returns a command in the form: AUDMIC_STEREO-<ENABLED|DISABLED>
AUDMIC_STEREO
Enables or disables single
stereo mode
Enable or disable single stereo mode in two MIC input channels
Syntax:
SEND_COMMAND <DEV>,"'AUDMIC_STEREO-<ENABLE|DISABLE>'"
Example:
SEND_COMMAND <DEV>,"'AUDMIC_STEREO-ENABLE'"
?AUDOUT_STEREO
Request if audio amp output
is in stereo
Device responds with "'AUDOUTSTEREO-<setting>'" where setting is
"ENABLED" or "DISABLED".
Syntax:
SEND_COMMAND <device>, "'?AUDOUT_STEREO'"
Example:
SEND_COMMAND dxDev, "'?AUDOUT_STEREO'"
