![background image](http://html1.mh-extra.com/html/amx/dcp-mtx/dcp-mtx_user-manual_2939027014.webp)
14
USER MANUAL
DCP-MTX
1).
b) Login Web UI through a web browser (Default IP address of DCP-MTXs
is192.168.1.121).
c) Go to Configuration > Device > Daisy-chain Sequence. Select Daisy-chain
quantity and click “Start Sequence” to allocate IP addressing to each
DCP-MTX.
4. Connect source, display devices and/or audio devices to DCP-MTXs.
5. If output scaling is needed, please connect DCP-SRX by referring to “SYSTEM
WIRING (with DCP-SRX)” chart.
NOTE:
• Default IP address of DCP-MTX is 192.168.1.121.
• The PC used to login Web UI of DCP should be set in the same network segment
as DCP-MTX, e.g. 192.168.1.x.
• For information about accessing and operating Web UI, please refer to “8.2 WEB
UI”.
• To avoid IP addressing conflicts, please repeat Step 2 if any DCP-MTX is reset,
removed from and added to the connection.
• To make CEC control effective, please use CEC-enabled display devices.
• Quality CAT cables, e.g. Cat6, AWG23 or S/FTP cable, are highly recommended.
For more information about HDBaseT transmission cables, please visit: www.
hdbaset.org/cable.
• For users who prefer to control the DCP-MTX or DCP connection system through
a contact closure-based keypad, please ensure there’s no resistor exsits among
contact closure ports of MYTURN, KEY and LED (as shown in the circuit diagram
below):
Key
G
LED
G
Max.5mA