Network Configuration
59
Hardware Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
To restore Wallplate TX or Decor Wallplate TX to its factory default firmware image:
NOTE:
ID Pushbutton and the Reset button are located on the left edge of the Wallplate TX and on the front of the Decor Wallplate TX.
1.
Press and hold the ID Pushbutton. While the ID Pushbutton is down, press and release the Reset button. Start counting when
the NetLinx LEDs begin to flash in unison, not when the Reset button is released.
After the LEDs complete the following sequence, release both buttons:
Once the unit has started booting up, all LEDs flash in unison at the rate of once per second.
After 10 flashes at that rate, the LEDs will blink in unison at a faster rate.
After 10 seconds of flashing at the increased rate, all LEDs go to solid on.
2.
Upon release, the unit executes the following actions:
a.
Restores itself to its factory firmware image.
b.
Resets to factory default parameters*:
Deletes all IRL files stored on the device.
Resets to the default static IP address of 192.168.1.2 and default DHCP address of 169.254.2.2.
Resets to the default device number of 0 (when bound to a Master, receives a dynamic device number from the Master).
Resets to NDP mode and being unbound.
* For a complete list of factory parameters, see the table on page 55.
3.
Once all actions in Step 3 are completed, the LEDs all turn off, indicating the unit is ready to reboot.
The unit automatically reboots to complete the process.
TIP:
To monitor the ID Pushbutton boot state of a module, see the “ID Pushbutton Boot and NetLinx LED Behavior” table below.
ID Pushbutton Boot State and LED Behavior
To monitor the ID Pushbutton boot state of a module by its LEDs, check both the Link/Act and Status LED columns.
ID Pushbutton Boot and NetLinx LED Behavior
ID Pushbutton Boot States
Link/Act LED
Status LED
Boot with ID Pushbutton held down
Slow blink (1 Hz)
Slow blink (1 Hz)
ID Pushbutton held down long enough for reset to
default parameters
Fast blink until ID Pushbutton is
released, then OFF
Fast blink until ID Pushbutton is released, then
OFF
ID Pushbutton held down long enough for reset to
default firmware image
Solid ON, transitions to OFF once
the unit completes writing to
flash and is ready to reboot
Solid ON, transitions to OFF once the unit
completes writing to flash and is ready to reboot
In Auto ID mode
Normal
Blink (2 Hz)
ID Pushbutton held down long enough to accept
new ID
2 blinks, then normal
2 blinks, then normal
After boot: ID Pushbutton held down, but not long
enough for IP mode change
Slow blink (1 Hz)
Slow blink (1 Hz)
After boot: ID Pushbutton held down long enough
for IP mode change
Fast blink, then OFF
Fast blink, then OFF
