39
The WPS provides below methods:
¾
PBC:
Using routers and physical or logical button on a wireless device to connect WPS.
You have below methods to connect WPS:
1
ǃ
Using the router WPS button on the rear panel for the PBC connection
ķ
Click “
Enable
”
ĸ
Click “
Save
”
Ĺ
Hold the router on the rear panel of the WPS button for 3 seconds, then let go
ĺ
The router's WPS led flashes two minutes, During this time, In the wireless client devices use
the WPS/PBC connect to your wireless signal
Knowledge Expansion
resetOOB:
z
The router wireless SSID, safe mode resumed to not configured mode. Make the WPS reset
the SSID, Encryption and password, after the completion of the reset, the router’s SSID is
factory default, safe mode is unencrypted.
3.5.4
Access
Control
Wireless access control is actually based on the MAC address to permit or forbid specified
clients to access the wireless network
Set Steps
˖
ķ
Click “
WLAN Settings
”.
ĸ
Select “
Access Control
”
.
Summary of Contents for WR3011
