AMS Neve 88D, User Manual

Page: 65 / 85

88D User Manual
65
Now use the Master REC, PLAY, TRIM and GLIDE keys to change the Mode of
controls in Scope (i.e. without using the ALL/SCOPE key as well).
If the Master ISOLATE key is pressed then all controls in scope will be Isolated and
taken out of scope.
To place controls in a path in Scope without changing the Automation Mode toggle
the state of the DESK AUTO, CUT AUTO and FADER AUTO keys as required. Press
and hold the ALL/SCOPE key then press the required ACCESS key. All controls in
the path will be put in Automation Scope, except those excluded by the DESK AUTO,
CUT AUTO and FADER AUTO keys. The current Automation Modes of controls will
remain unaffected. Release the ALL/SCOPE key.
The ACCESS keys for as many paths as necessary can be pressed while the
ALL/SCOPE key is held down.
To remove individual Faders or CUT keys from Scope isolate the control by holding
the associated mode key and pressing the isolate key by that fader.
To remove all controls from Scope and Isolate them press and hold the ALL/SCOPE
key and press the ISOL key.
Mix/Pass Trees
Mix/Passes are organised in a Mix/Pass Tree. The Mix/Pass Tree shows the order in
which Mix/Passes were created and the lines of revision used to create each
Mix/Pass.
The Mix/Pass Tree is displayed graphically so that Mix/Pass dependencies are
shown clearly.
A Mix/Pass Tree always starts with Mix/Pass
1.1.
A Mix/Pass Tree is displayed graphically for
selecting a Mix/Pass revision as the Play Pass
or editing the Tree.
Mix/Passes
Each Mix/Pass contains:
An Event List containing an Initial Snapshot (ISS) followed by Automation
Events
Automation Modes and Automation Scope as they were when timecode
stopped at the end of the pass
A Label List
A Safety Snapshot