
Chapter 3 - Using the Web Configuration Server
Figure 53: Routing Table
Routing Table settings are used to setup the functions of static and
dynamic routing. The Routing Table window includes the following
parameters:
Table 38: Routing Table Parameters
Parameter
Description
Dynamic Routing
Routing Information Protocol (RIP) will exchange information
on destinations for computing routes throughout the network.
Select RIPv2 only if you have a different subnet on your
network. Otherwise, select RIPv1 if you need this protocol.
Static Routing
For static routing, you can specify up to 8 routing rules. You
can enter the destination IP address, subnet mask, and
gateway, hop for each routing rule, and enable/disable the
individual rule.
Default Route
Sets the default route interface as WAN or LAN. For LAN,
one IP for routing must be set.
Using the Web Configuration Server
78
Summary of Contents for TE1088
