32 - EN
Cleaning the Areas of the SpaLet
®
Seat That Are Covered by the Seat Unit
1. Remember to remove the power plug from the wall outlet.
* If the water heater operates with no water in the tank, it
could cause smoke or fire.
2. Do not pull on any cord or water supply hose.
* Doing so may lead to damage or a water leak.
3. Carefully handle the seat unit when removing or cleaning.
* Failure to do so may lead to water leakage.
4. Never turn the seat unit upside down while it is
connected to the power supply.
* It could cause damage to this product.
2. Close the water shut-off valve to cut off the water
supply. (See caution 2.)
Since the water shut-off valve is adjusted beforehand,
keep track of the turns so you can return the valve to
its original position.
1. Remove the power plug from the wall
outlet. (See caution 1.)
1. Removing the seat unit
* When removing this product, slide the unit slowly without holding the SpaLet seat or
seat lid. Do not use excessive force.
3.
Slide this product forward,
raise it
slightly
, and remove it
from the SpaLet seat. (See caution 2, 3 and 4.)
Pull the lock lever on the right side of the seat unit.
4. Carefully place the seat unit on
the rim of the toilet bowl.
1
2
CAUTION
* Do not pull.
* Do not reverse
* Do not place on
the floor.
Turn clockwise.
Water shutoff valve
Slide
forward
Lock lever
1
2
Lock lever
Hold the lower part of the
SpaLet seat and pull.
Lock lever
● Do not reverse
● Do not place on
the floor.
● Do not pull.
Turn clockwise
Water shut-off
valve
Summary of Contents for Advanced Clean 3.0 SpaLet
Page 54: ...51 EN ...
