PROGRAMMING
9
The display will show:
Press
or
to change the flashing value to current day.
Press
when done.
The display will show:
Press
or
to change the flashing value to current time in one
minute increments.
Press and hold
or
to change to current time in thirty minute
increments.
Press
when done.
(12:00 AM)
(12:00 PM)
The display will show:
Door Frame Heater Settings
This function will turn the door frame heater on (“Y”) or off (“N”).
By default, the door frame heater is set to on. If you wish to turn the door frame heater off, change the
flashing value from “Y” to “N”(off) by pressing
or
.
Press
when done.
Note:
If you set the flashing value to “N”, door frame heater off, the controller will skip to alarm settings. In
case the flashing value is set to “Y”, door frame heater on, the controller will guide you thru door frame
heater settings.
The display will show:
This function will display the walk-in temperature which will determine when the
door frame heater will start.
Set the air temperature inside the walk-in at which the door frame heater will
start. To do so press
to increase or
to decrease the flashing
value representing the air temperature.
Press
when done.
Summary of Contents for Walk-in Monitoring System 200
