PROGRAMMING
15
The display will show:
Adjust the Probe Temperature Offset
Press
or
to match the flashing value with the temperature offset
(
T
OFFSET
)
calculated in Appendix 1 of this manual.
When finished, press
.
The display will show:
This setting is for factory technician only. Press
to skip.
The display will show:
This setting is for factory technician only. Press
to skip.
The display will show:
Configure The PC Connection
This setting enables or disables the PC connection. If you purchased the PC
connection kit make sure you enable the PC connection.
Note:
If you disable the PC connection (flashing value set to “N”), the controller will skip the PC connection
settings.
To enable the PC connection, set the flashing value to “Y” by pressing
or
.
When finished, press
.
The display will show:
Set the Controller’s Id Number
The Id number identifies that particular controller when there is more then one
controller connected to the same PC. Set different Id numbers for each
WIMS 200 controller connected to the same PC. To do so, change the flashing
value by pressing
or
.
When finished, press
.
Summary of Contents for Walk-in Monitoring System 200
