American Megatrends Super Voyager LPX, User Manual

Page: 188 / 200

AMIFlash,
Continued
Chapter 6 AMIFlash Utility
182
Message Explanation
Disk
Reading BIOS File
from Disk Displayed when the file with which Flash EPROM will be
programmed is being read from the disk.
Press <ESC> to Exit When this message is displayed, you can exit AMIFlash
by pressing <Esc>.
Press Any Key to Exit Usually displayed below another message when a fatal
error occurs, for example, no Flash EPROM present in
system or the hardware is not accessible.
Press Any Key to
ReBoot Displayed after successful Flash EPROM programming.
Want to Continue? Displayed after an error message.
Want to Exit (Y/N)? Displayed when you press <Esc>.
Please Wait.. Displayed when Flash programming is occurring.
Put Off System Power Displayed if there is an error during Flash programming.
Replace the Flash EPROM with a new programmed Flash
EPROM.
No Flash EPROM
present Displayed if no Flash EPROM is present in the system.
Memory Allocation
Error Displayed when scratch memory is not available.
File Creation Error Displayed when the specified BIOS save file could not be
created.
File Does Not Exist Displayed when the Flash EPROM program file could not
be found.
File I/O Error Displayed during a read or write error.
Disk Full Displayed when the disk where the existing BIOS was to
be saved has no space.
Flash EPROM
Programming Error. Displayed if an error occurs during Flash programming.
The system is not usable unless the existing Flash EPROM
is replaced with the new Programmed Flash EPROM.
BIOS File Not Of
Proper Size Displayed when the file size of the new program does not
match the Flash EPROM size.
Flash EPROM
Programming is going
to start The system is not usable until Flash EPROM
programming is completed successfully. If an error occurs,
the existing Flash EPROM must be replaced by a new
programmed Flash EPROM. The system must not be
turned off during programming. The system reboots if
programming is completed successfully.