46
RG500 Series
Minimum Speed (MIN OUT), Maximum Speed
(MAX OUT) & Signal Input Adjust (-PCM models)
The following minimum and maximum values should be known.
INmin
- Minimum analog input signal.
INmax
- Maximum analog input signal.
OUTmin
- Minimum analog output signal.
OUTmax
- Maximum analog output signal.
INmin
and
INmax
is the voltage applied across terminals 7(COM) and
8 (INPUT 1) or 9 (INPUT 2).
OUTmin
and
OUTmax
is the voltage across
terminals 1 (OUT 1) and 2 (OUT 2) that connect to the lower board.
Calibration Procedure
1. Ensure that switch SW501 on the -PCM board is properly set. See
page 29 for switch settings.
2. Connect (but do not power) the analog input signal as follows.
- Connect the signal negative (-) to terminal 7 (COM).
- For a current signal or a 0 - ± 25 VDC voltage signal, connect the
-
signal positive (+) to terminal 8 (INPUT 1).
- For a 0 - ± 250 VDC voltage signal, connect the signal positive (+) to
-
terminal 9 (INPUT 2).
Summary of Contents for Minarik DRIVES RG500 Series
Page 70: ...61 RG500 Series Notes...
