35
RG500 Series
The switch shown in Figure 18 may be used to decelerate a motor to
a minimum speed. Closing the switch between S0 and S2 decelerates
the motor from set speed to a minimum speed determined by the MIN
SPD trim pot setting. If the MIN SPD trim pot is set full CCW, the motor
decelerates to zero speed. The REV ACC or FWD ACC trim pot setting
determines the rate at which the drive decelerates, depending on the
direction of deceleration. By opening the switch, the motor accelerates
to set speed.
Regenerative Decel to Minimum Speed
S1
or
S3
S2
S0
RUN
DECEL TO
MIN SPEED
10K OHM
SPEED ADJUST
POTENTIOMETER
CW
Figure 18. Run/Decelerate to Minimum Speed Switch
Summary of Contents for Minarik DRIVES RG500 Series
Page 70: ...61 RG500 Series Notes...