AMCI NR60E2, User Manual

Page: 36 / 98

S
ET THE
IP A
DDRESS AND
P
ROTOCOL
NR60E2 User Manual
ADVANCED MICRO CONTROLS INC.
36
3.3c Use the Embedded Web Server
PREREQUISITE: You must know the present IP address of the NR60E2. The factory default address is
192.168.0.50. If you do not know the address, use the information in section 3.3b, Use the NR60E2 IP
Address Switches , to set the Address Switches to ‘999’. This sections starts on page 35. This sets the IP
Address to 192.168.0.50 regardless of the data stored in flash memory.
These instructions assume that the Address Switches are set to “999”. If they are instead set in
the range of “001” to “254”, the last octet of the IP address is set by the Address Switches.
With these settings, the subnet can be changed, but the last octet of the programmed address
must match the switch settings.
PREREQUISITE: Task 2.1: Power Wiring Installation , found on page 29. You must be able to power the
NR60E2.
PREREQUISITE: Task: 2.2: Ethernet Wiring Installation , found on page 30. You must attach your
NR60E2 to your computer.
PREREQUISITE: The network interfaces on your computer must be on the same subnet before you can
communicate with an NR60E2. Refer to Configuring Network Interfaces , which starts on page 21, for addi-
tional information
3.3c.1 Disconnect the NR60E2 from the host controller and cycle power to the NR60E2.
This ensures that the unit does not have any open connections to the host controller.
This method allows you to change the IP Address, Subnet Mask, and Default Gate-
way values. This method is available on all NR60E2 units sold in or after Septem-
ber, 2019. The unit’s serial number can be used to determine the date of
manufacture. The first for digits of the serial number are the month and year of
manufacture. If the NR60E2 was manufactured prior to September, 2019, the AMCI
NET Configurator software can be used to set the IP Address.