AMCI NR60E2, User Manual

Page: 29 / 98

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
29
TASK 2
W
IRE
P
OWER AND
E
THERNET
2.1 Power Wiring Installation
2.1.1 Power Wiring Guidelines
The NR60E2 requires a power supply of 12 to 48 Vdc, (11 to 54 Vdc as absolute maximums). Power require-
ment is 2.5W, or approximately 100 mA @ 24Vdc.
Because of the low power requirements, NR60E2 power wiring should not be run with high power AC or DC
cabling.
2.1.2 Connector Location and Pinout
Figure T2.1 below shows the power connector location on end and side connect units as well as the connector
pinout.
Figure T2.1 NR60E2 Connector Placement
2.1.3 Right Angle Cable Exit Direction
When designing a mounting solution for the NR60E2, be aware of the cable exit direction when using right
angle mating connectors. Figure T2.1 above shows the direction of the cable when using AMCI, TURCK, or
Phoenix Contact cordsets.
2.1.4 Mating Connectors and Cordsets
AMCI offers the following mating connector and cordsets that mate with the NR60E2 power connector. Note
that the power connector will mate with any connector or cordset that follows the M12, 4 pin, A-coded standard.
Table T2.1 Compatible Connectors and Cordsets
AMCI # Description
MS-29
Mating connector for Power connector.

Screw terminal connections. 6 to 8 mm dia. cable. 18 AWG max.

Straight, IP67 rated when properly installed.
CNVL-2M
Molded cordset for Power connector. 22 AWG wire, 2 meters in length.

Straight connector to flying leads. IP67 rated when properly installed.
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
NR60 Connector Placement
POWER: M12 - A Coded
Male Female
Pin 1:
12-48 Vdc
Pin 2:
N. C.
Pin 4:
N. C.
Pin 3:
GND
POWER
Exit Direction
of
Right Angle Cables
POWER
PORT 1
PORT 1
PORT 2
PORT 2
PORTS 1&2: M12 - D Coded
Pin 2:
RxD+
Pin 1:
TxD+
Pin 3:
TxD–
Pin 4:
RxD–