![AMCC 3WARE 9500S Manual Download Page 47](http://html1.mh-extra.com/html/amcc/3ware-9500s/3ware-9500s_manual_2921146047.webp)
Controller Object Commands
www.3ware.com
39
group=3|4|5|6
indicates the number of disks per group for a RAID 50 type.
(This attribute can only be used when type=raid50.) Recall that a RAID 50 is
a multi-tier array. At the bottom-most layer, N number of disks per group are
used to form the RAID 5 layer. These RAID 5 arrays are then integrated into a
RAID 0. This attribute allows you to specify the number of disks in the RAID
5 level. Valid values are 3, 4, 5 and 6.
Note that a sufficient number of disks are required for a given pattern or disk
group. For example, given 6 disks, specifying 3 will create two RAID 5
arrays. With 12 disks, specifying 3 will create four RAID 5 arrays under the
RAID 0 level. With only 6 disks a grouping of 6 is not allowed, as you would
basically be creating a RAID 5.
The default RAID 50 grouping varies, based on number of disks. For 6 and 9
disks, default grouping is 3. For 8 disks, the default grouping is 4. For 10
disks, the default grouping is 5, and for 12 disks, the default grouping is 4. In
the case of 12, the disks could be grouped into groups of 3, 4, or 6 drives. A
grouping of 4 is set by default as it provides the best of net capacity and
performance.
noscan
attribute instructs CLI not to notify the operating system of the
creation of the new unit. By default CLI will inform the operating system.
One application of this feature is to prevent the operating system from
creating block special devices such as /dev/sdb and /dev/sdc as some
implementations might create naming fragmentation and a moving target.
nocache
attribute instructs CLI to disable the write cache on the newly
created unit. Enabling write cache increases write performance at the cost of
potential data loss in case of sudden power loss (unless a BBU or UPS is
installed). By default the cache is enabled. To avoid the possibility of data loss
in the event of a sudden power loss, it is recommended not to set nocache
Table 7: Supported Stripe Sizes (KB)
Model
R0
R1
R5
R10
JBOD
Spare
R50
Single
7K/8K
64
N/A
64
64
N/A
N/A
N/S
N/S
128
128
256
256
512
512
1024
1024
9K
16
N/A
16
16
N/A
16
N/A
64
64
64
64
256
256
256
256