Controller Object Commands
www.3ware.com
33
/cx show ctlbus
This feature only applies to 9550SX and 9590SE controllers.
This command reports the controller host bus type, bus speed, and bus width.
Example:
//localhost> /c0 show ctlbus
/c0 Controller Bus Type = PCIX
/c0 Controller Bus Width = 64 bits
/c0 Controller Bus Speed = 133 Mhz
/cx show exportjbod
This feature only applies to 9000 series controllers.
This command reports the current JBOD Export Policy:
on
,
off
, or
Not
Supported
.
Example:
//localhost> /c0 show exportjbod
/c0 JBOD Export Policy = Not Supported.
//localhost> /c1 show exportjbod
/c1 JBOD Export Policy = on
/cx show spinup
This feature only applies to 9000 series controllers.
This command reports the number of concurrent disks that will spin up when
the system is powered on, after waiting for the number of seconds specified
with the
set stagger
command.
Example:
//localhost> /c0 show spinup
/c0 Disk Spinup Policy = 1
/cx show stagger
This feature only applies to 9000 series controllers.
This command reports the time delay between each group of spinups at the
power on.
Example
:
//localhost> /c0 show stagger
/c0 Spinup Stagger Time Policy (sec) = 2
