2. Remove the bolts.
3. Install the desired wheel mark eradicator coulter
on the tool carrier.
4. Install the bolts.
5. Install the nuts and tighten them.
6. After 5 hours of operation, check the bolt
connection for tight fit.
6.4.11.4 Deactivating the wheel mark eradicator
The wheel mark eradicator
1
is automatically
swivelled into working position as soon as the
implement is unfolded. The wheel mark eradicator is
locked in parking position with the control lever
2
.
CMS-I-00003942
1.
To deactivate the track marker,
fold the implement.
2. Put the control lever in the locked position.
The implement is now unfolded without the wheel
mark eradicator swivelling down.
CMS-I-00003938
6.4.12 Setting up the speed sensor on the implement
To start the metering unit or the electronic monitoring,
a speed signal is required. The speed sensor on the
implement can be used for this.
1. Set up the speed sensor on the implement.
CMS-T-00005575-A.1
CMS-T-00001908-B.1
6 | Preparing the machine
Preparing the implement for operation
MG6967-EN-II | C.1 | 27.09.2021
89
