Coupling and uncoupling the machine
Centaur BAG 0070.1 12.08
67
7.2
Uncoupling the machine
WARNING
Risk of contusions, cutting, catching, drawing in and knocks
through insufficient stability and possible tilting of the
uncoupled machine!
Place the machine due to the high supported load, only on a
horizontal storage space with a solid base.
When uncoupling the machine, there must always be enough space
in front of the machine, so that you can align the tractor with the
machine if necessary.
The
Centaur 4001 -2/5001-2
can be uncoupled as follows:
When folded out.
Place the machine on the tines.
When
retracted.
Place the machine on the stand.
1. Park the machine on a level parking surface on solid ground.
2. Uncouple the machine from the tractor.
2.1 Secure the machine against unintentionally rolling away.
See page 64.
2.2 Lower the stand (where applicable).
2.3 Release the lower link.
At the same, simultaneously actuate control unit 1.
Lower the running gear, thus keeping the machine
horizontal.
2.4 From the tractor seat, unlock the lower link hooks and
uncouple them.
2.5 Pull tractor forward approx. 25 cm.
This will allow more room between tractor and machine and
give better access for uncoupling the PTO shaft and supply
lines.
2.6 Secure tractor and machine against unintentional starting
and rolling away.
2.7 Disconnect the supply lines.
2.8 Fasten supply lines to their respective parking sockets.
3. Secure the machine against rolling away with wheel chocks.