Cleaning, maintenance and repairs
88
Centaur BAG 0070.1 12.08
11.6
Changing the coulter (workshop work)
WARNING
Danger of injury or death from unintentional lowering of the
raised implements.
Close the stop tap to prevent lowering of the coulter, see page 33.
CAUTION
Take special care when changing
coulters.
Do not turn the screws on the
square shaft.
Risk of injury from sharp edges.
Fig. 55
11.6.1
Changing the Vario-Clip coulter (workshop work)
To remove the Vario-Clip coulter (Fig. 56/1),
knock the spiral pin (Fig. 56/2) out by knocking it
downwards using a drift and remove the coulter
towards the front.
To install the Vario-Clip coulter, slide it in and
secure with the spiral pin.
CAUTION
Coulters are made of hardened
material. If you use a hammer for
the mounting/removal procedures,
the ends may break off and cause
considerable injury.
You must wear protective goggles
and gloves.
Fig. 56
